1.26 CAMSHAFT GEAR ASSEMBLY SERIES 60 EXHAUST GAS RECIRCULATION (EGR) MODEL NOTICE: If the camshaft gear cover bolts and/or the camshaft cap bolts are tightened down with the camshaft gear out of time damage to the camshaft gear cover and the timing pin will result. 13. Install No. 1 and 7 camshaft bearing caps with one bolt and one stud bolt in each and hand tighten. See Figure 1-401. 1. Bolt 2. Stud Bolt Figure 1-401 Camshaft Bearing Cap Bolt and Stud Bolt 14. Install the the remaining five camshaft caps in the following sequence; caps 3, 6, 2, 5 and 4. Hand tighten to prevent seal damage to the backside of the camshaft cover. 15.
Install three bolts inside camshaft gear cover, hand tighten to prevent seal damage. 16. To seat the cover, torque the three inside camshaft gear cover bolts to 10 N·m (7 ft·lb). (Rev. 2005) All information subject to change without notice. 1-442 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION