Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.27.2 Removal of Thrust Plate Perimeter Seal Remove the thrust plate perimeter seal as follows: 1. Remove the air cleaner and charge air cooler ducting from the turbocharger and air intake manifold. Refer to section 6.2.2. 2. If the upper radiator hose prevents removal of the valve rocker cover, drain coolant into a suitable container until it is below the level of the thermostat housing outlet. Then disconnect the hose from the thermostat housing. Refer to section 4.4.2. 3. Remove the valve rocker cover. Refer to section 1.6.1. 4. Remove the five bolts that secure the camshaft drive gear access cover to the gear case cover. See Figure 1-406.

Figure 1-406 Camshaft Drive Gear Access Cover and Adjustable Idler Gear Access 5. Remove Jake Brakes®, if equipped. Refer to section 1.36.2. 6. Remove the rocker and rocker shaft assemblies. Refer to section 1.3.2. 7. Using LPS® Contact Cleaner or equivalent residue-free solvent, clean the gear case back/thrust plate area to improve visual access to the seal area. Wipe the area dry with paper towels. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-447