SERIES 60 SERVICE MANUAL NOTICE: Always use a new bolt when replacing the camshaft hub. The camshaft retaining bolt is considered a single-use item and cannot be reused, regardless of apparent condition. Reusing this bolt may result in excessive bolt stretch, which could lead to loss of bolt torque, hub loosening, and severe engine damage. 15. Coat the threads and underside of the head of the camshaft drive gear-to-camshaft bolt with International Compound #2. Check the marks previously made on the gear teeth to ensure proper cam gear timing. Install the bolt to the camshaft, finger tighten. NOTICE:
Only retaining tool (J–35652–B) should be used to hold the camshaft drive gear stationary while loosening or tightening the camshaft drive gear-to-camshaft bolt to prevent component damage. NOTE: The camshaft should be held in place while starting the camshaft drive gear-to-camshaft bolt, to prevent disengaging the camshaft dowel from the thrust plate hub, requiring disassembly and timing of the camshaft. 16. Insert retaining tool (J–35652–B) through a lightening hole of the camshaft drive gear. 17. Using the 3/4 in.
square hole in the center of the crankshaft pulley, bar the engine over slightly to position the camshaft drive gear holding tool so that the bolt holes in the holding tool align with the access cover bolt holes in the gear case cover. 18. Install two of the access cover bolts to secure the tool to the gear case cover. NOTE: Ensure any residual oil is removed from the dowel face of the camshaft and mating hub before installing the drive gear. 19. Apply a light coating of International Compound #2 to the camshaft drive gear mounting bolt threads and the underside of the bolt head.
Using a 27 mm impact socket and suitable torque wrench, torque the camshaft drive gear-to-camshaft bolt to 75 N·m (55 lb·ft). Then turn the bolts clockwise 120 degrees (two flats of the bolt head) to achieve the required torque. 20. Remove camshaft drive gear torque retaining tool (J–35652–B). 21. Install the access cover plate to the gear case cover. Refer to section 1.10.3. 22. Install the rocker and rocker shaft assemblies. Refer to section 1.3.3. 23. Install the Jake Brakes, if equipped. Refer to section 1.36.5. 24. Install the valve rocker cover. Refer to section 1.6.7 or refer to section .
Install or reconnect any other components that were removed or disconnected for this procedure1.6.8 . All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-457