SERIES 60 SERVICE MANUAL 1.28.6 Installation of Camshaft and Camshaft Bearing Continue installing camshaft and camshaft bearings as follows: 1. Install the bearing shells to the remaining No. 2, 3, 5, and 6 camshaft caps, noting the oil holes and locating tangs. 2. Coat the bearing shells with clean engine lubricating oil. 3. Install the remaining camshaft caps to their saddles on the cylinder head. Install the four outboard camshaft cap bolts for caps No. 2, 3, 5, and No. 6 finger-tight. 4. Coat the rocker arm assemblies and camshaft liberally with clean engine lubricating oil. 5. Install the rocker arm shaft assemblies to the cylinder head. Refer to section 1.3.3. 6.
Install the remaining inboard camshaft cap bolts and spacers through the rocker arm shafts and into No. 2, 3, 4, 5, and 6 camshaft caps. Install the two nuts and spacers to the studs at No. 1 and 7 camshaft caps. 7. Torque the 11 bolts and two nuts to 126-146 N·m (93-108 lb·ft) using the sequence. See Figure 1-437. NOTE: It is not necessary to tighten bolts 9, 13, and 14 if a Jake Brake is to be installed. NOTE: Jake Brakes are not on a natural gas engine. Figure 1-437 Camshaft Cap Bolts and Rocker Arm Shaft Nut Torque Sequence All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-483