Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1. Drain the cooling system. Refer to section 14.6.4. 2. Drain the engine lubricating oil. Refer to section 14.6.1. 3. Remove the oil pan. Refer to section 3.11.2. 4. Remove the camshaft gear assembly. Refer to section 1.26.2. 5. Remove the gear case cover. Refer to section 1.11.2. NOTICE: Always use crankshaft protector (J–35994) to guard against damage to the oil seal area of the crankshaft. When removing the bull gear or camshaft idler gear and hub assembly, do not come in contact with the oil seal contact surface of the crankshaft. If sealing surface is scratched, an oil leak may result. 6. Install J–35994 to the oil seal contact area of the crankshaft.

See Figure 1-461. Figure 1-461 J–35994 Crankshaft Protector 7. Remove bull gear and camshaft idler gear. Refer to section 1.32.2. 8. Remove three adjustable idler gear nuts from stud and stud bolts. Discard nuts. 9. Remove the adjustable idler gear hub retaining plate. 10. Remove the adjustable idler gear and idler hub. 1.31.2.1 Inspection of Adjustable Idler Gear Assembly Inspect the adjustable idler gear as follows 1. Wash the adjustable idler gear, idler hub, and retaining plate thoroughly in clean fuel oil. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-515