Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2. Install J–35994 to the oil seal contact area of the crankshaft. See Figure 1-466. Figure 1-466 J–35994 Crankshaft Protector NOTICE: Use care when removing the bull gear and camshaft idler gear assembly from the engine so that it does not come in contact with the oil seal contact surface of the crankshaft. If this sealing surface is scratched, an oil leak may result. 3. Grasp the bull gear and pull the assembly straight out and off the spindle. 1.32.2.1 Inspection of Bull Gear and Camshaft Idler Gear Assembly Inspect the bull gear and camshaft idler gear assembly as follows: 1. Clean the bull gear and idler gear assembly in clean fuel oil.

To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. EYE INJURY 2. Dry the bull gear and idler gear assembly with compressed air. 3. Visually examine the gear teeth on both the bull gear and idler gear for evidence of scoring, cracking, pitting, and wear. [a] If either gear is damaged, replace the bull gear and idler gear assembly. [b] If either gear is not damaged, reuse the bull gear and idler gear assembly. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-521