Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.33 BULL GEAR AND CAMSHAFT IDLER GEAR ASSEMBLY The bull gear and camshaft idler gear are a press-fit to the bull gear and camshaft idler gear carrier. See Figure 1-470. 1. Woodruff Key 8. Snap Ring, Inner 2. Camshaft, Idler Gear 9. Snap Ring, Outer 3. Bearing Race, Outer 10. Bearing, Outer 4. Spacer Ring, Small 11. Spacer Ring, Large 5. Hub 12. Carrier 6. Bearing, Inner 13. Bull Gear 7. Bearing Race, Inner 14. Thread Nut, Left Hand Figure 1-470 Bull Gear and Related Parts Both gears are keyed to the carrier by the same key. For units built prior to 6R11886, a spacer ring fits in a groove in the carrier between the bull gear and the camshaft idler gear.

For units built after 6R11887, this spacer was incorporated in the carrier. The carrier is supported by two tapered roller bearing assemblies that ride on a hub bolted to the engine block by four bolts. A selective-size spacer between the two bearing assemblies is used to obtain the correct bearing preload. NOTE: The bull gear and camshaft idler gear assembly is retained to the hub by a left-hand threaded nut. (Rev. 2005) All information subject to change without notice. 1-526 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION