Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 6. Align the timing marks on the camshaft drive gear and the adjustable idler gear as shown. See Figure 1-478. 7. Slide the bull gear and camshaft idler gear assembly towards the engine, but do not engage any of the gears on the engine. 8. Looking through the access hole in the bull gear, align the timing marks on the adjustable idler gear and the camshaft idler gear as shown. See Figure 1-478. 9. Check the timing marks on the bull gear and crankshaft timing gear to ensure they will align when the bull bear assembly is seated in the cylinder block. NOTE: The injector and valve spring pressures will not allow easy rotation of the camshaft and adjustable idler gears.

Therefore, it may be necessary to remove the rocker arm shaft assemblies to facilitate aligning all three sets of timing marks. Refer to section 1.3.2. 10. When all three sets of timing marks are aligned, slide the bull gear and camshaft idler gear towards the engine completely and seat it in the recess in the gear case and cylinder block. NOTICE: Use care when installing the bull gear and camshaft idler gear assembly to prevent damaging the crankshaft oil seal contact surface. 11. Working through the lightening holes in the bull gear, install two of the bull gear assembly mounting bolts through the hub and into the cylinder block. Tighten the bolts finger-tight. 12.

Remove the two bull gear guide studs. 13. Install the remaining two bull gear assembly mounting bolts. Torque all four mounting bolts to 101-116 N·m (75-86 lb·ft) in a clockwise direction. 14. Check the timing marks on the gears to ensure the gear train is properly timed. See Figure 1-478. 15. Check the gear lash for all of the gears that mate with the bull gear and camshaft idler gear. Refer to section 1.24. 16. Install the gear case cover. Refer to section 1.10.3. 17. Check bull gear to accessory drive gear lash. Refer to section 1.24.2.1. 18. Refer to section 12.7 for verification of proper bull gear and camshaft idler gear assembly installation.

All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-537