Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.34 CRANKSHAFT TIMING GEAR AND TIMING WHEEL A timing wheel is installed on the crankshaft directly behind the crankshaft timing gear. The timing wheel is indexed to the crankshaft by the same key as the crankshaft timing gear, and is retained to the crankshaft by the crankshaft timing gear. The timing wheel is marked with the word OUT on the outboard side, and should be installed with this mark facing you as you install the wheel. See Figure 1-481. Figure 1-481 Crankshaft Timing Gear and Related Parts Location The timing wheel induces a voltage signal in the Timing Reference Sensor (TRS), as the teeth of the pulse wheel passes by the TRS.

This signal is sent to the Electronic Control Module (ECM) to determine injector firing. Since the crankshaft and camshaft must be in time with each other, a series of timing marks are stamped or etched on the faces of the gears in the gear train. Refer to section 1.24.2.1 for gear train timing information. The balance shafts and crankshaft must also be in time with each other. The crankshaft timing gear is lubricated by splash from the engine oil pan, and excess oil returning to the oil pan from the other gears.

1.34.1 Repair or Replacement of Crankshaft Timing Gear and Timing Wheel To determine if repair or replacement of the crankshaft timing gear and timing wheel are necessary, perform the following procedure. See Figure 1-482. (Rev. 2005) All information subject to change without notice. 1-540 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION