1.34 CRANKSHAFT TIMING GEAR AND TIMING WHEEL 1.34.2 Removal of Crankshaft Timing Gear and Timing Wheel Remove the gear and the timing wheel as follows: 1. Drain the cooling system. Refer to section 14.6.4. 2. Remove the radiator to engine coolant hoses. Refer to OEM guidelines. 3. Remove the timing reference sensor. Refer to section 2.32.2. 4. Remove components as necessary to gain access to the gear case cover. 5. Remove the gear case cover. Refer to section 1.10.2. 6. If an oversize crankshaft front oil seal sleeve is used, peen the outside diameter of the sleeve until it stretches sufficiently and slip the sleeve off of the crankshaft. Discard sleeve. 7.
Remove the oil pump inlet and outlet tubes. Refer to section 3.2.2. 8. Remove the oil pump. Refer to section 3.2.2. NOTICE: Use care when removing the bull gear assembly. To prevent damaging the crankshaft oil seal contact surface, use Crankshaft Protector (J–35994) on end of crankshaft or oil leaks may result. 9. Remove the bull gear and camshaft idler gear assembly. Refer to section 1.33.2. (Rev. 2005) All information subject to change without notice. 1-542 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION