Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.34 CRANKSHAFT TIMING GEAR AND TIMING WHEEL 11. Thread the three guide studs (J–35642–2, part of tool set J–35642) into the three threaded holes in the crankshaft timing gear. Finger-tighten the legs. 12. Slide the hydraulic ram (J–35951–175) over the center rod of J–35642–1 (part of tool set J–35642) and all the way to the base. See Figure 1-484. Figure 1-484 Hydraulic Ram Installation (Rev. 2005) All information subject to change without notice. 1-544 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION