1.34 CRANKSHAFT TIMING GEAR AND TIMING WHEEL 16. Remove the tools from the engine and timing gear as follows: [a] Open the valve on J–35951–175 to relieve the pressure. See Figure 1-487. [b] Loosen and remove the three retaining nuts on J–35642–2 (part of tool set J–35642) against the pressure plate. See Figure 1-484. [c] Remove J–35642–2 (part of tool set J–35642). [d] Remove J–35951–175. See Figure 1-485. [e] Loosen and remove the three guide studs (J–35642–2, part of tool set J–35642). [f] Loosen and remove the two crankshaft pulley bolts and remove the Base Post (J–35642–1, part of tool set J–35642). NOTICE: Care should be exercised when removing the timing wheel.
Do NOT use sharp tools to pry on the timing wheel. Damage to the crankshaft seal contact surface may cause oil leaks. 17. Slide the timing wheel off the end of the crankshaft. NOTE: The timing wheel is a slip fit to the crankshaft, and no special tools are required for removal. A three-jaw adjustable puller, however, may be necessary. (Rev. 2005) All information subject to change without notice. 1-548 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION