1.34 CRANKSHAFT TIMING GEAR AND TIMING WHEEL 8. Install the three retaining nuts to the puller legs. Thread the nuts past the first set of threads on the legs. Slide the nuts past the unthreaded portion of the shafts, and engage the second set of threads. Tighten but do not torque the retaining nuts. See Figure 1-494. Figure 1-494 Crankshaft Timing Gear Installation Tools 9. Install J–35951–175 to the base post rod. See Figure 1-494. 10. Install J–35642–3 (part of tool set J–35642) to the end of the base post threaded rod. Tighten the stop nut. (Rev. 2005) All information subject to change without notice. 1-554 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION