SERIES 60 SERVICE MANUAL 1.35.2 Removal and Cleaning of the Accessory Drive Precleaning is not necessary. Remove the accessory drive as follows: 1. Loosen the alternator mounting bolts and the adjusting rod nuts to get slack in the alternator drive belts. Remove the alternator drive belts. Refer to section 14.6.9. 2. Remove the five bolts that secure the accessory drive assembly to the gear case cover. 3. Remove the accessory drive assembly by pulling it straight out of the gear case cover to avoid damaging the rubber O-ring. See Figure 1-499. Figure 1-499 Accessory Drive Assembly Removal All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-561