Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.35 ACCESSORY DRIVE 12. Install the snap ring to the accessory drive housing making sure the snap ring is fully seated in the groove a full 360 degrees See Figure 1-518. Figure 1-518 Snap Ring Installation 13. Lubricate the contact surfaces of the bearing with clean engine lubricating oil. 14. A film of Lubriplate® must be applied to the drive gear end of the accessory drive shaft. See Figure 1-519. Figure 1-519 Drive Gear Installation Preparation (Rev. 2005) All information subject to change without notice. 1-578 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION