SERIES 60 SERVICE MANUAL 17. Measure sleeve and seal run out using tool J–45877 and a dial indicator. Total indicator deflection should not exceed 0.0762 mm (0.003 in.) for the sleeve and 0.1778 mm (0.007 in.) for the seal. If the run out is greater for either measurement, install a new seal. See Figure 1-522. 1. Dial Indicator 2. Seal Sleeve Figure 1-522 Seal Run Out Gauge Adaptor (J–45877) 18. Install the accessory drive pulley to the shaft. NOTE: If necessary, use tool J–36024–8 (part of toolset J–36024–C)to seat the pulley on the shaft. If pressing is necessary, the opposite (gear) end of the shaft must be supported during the pressing operation. 19.
Attach J–36024–3 (part of toolset J–36024–C) to the drive gear. See Figure 1-500. 20. Place the accessory drive assembly holding fixture into a vise. See Figure 1-523. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-581