SERIES 60 SERVICE MANUAL NOTICE: While tightening the screw on the torsion spring, push the spring toward the slave piston assembly. Failure to do so may result in contact between the intake valve adjusting screw and torsion spring. Serious engine damage may result. 6. Torque the screw to 20 N·m (15 lb·ft.). 7. Torque the slave piston leveling screw locknut to 47 N·m (35 lb·ft.). 1.36.5 Installation of Model 760, 765, or 770 Jake Brake Install the model 760, 765, or 770 Jake Brake as follows: NOTE: The following procedures apply to Model 760, 765, and 770 Jake Brake. For Model 790/795 Jake Brake installation procedures, refer to section 1.36.8. 1.
Adjust the intake and exhaust valve clearances and set the injector heights. Refer to section 13.2. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Attach the length of tubing to a blow gun nozzle, and blow out the oil from the bolt holes. 3. Cover the holes with hand towels to minimize oil spray. NOTE: Removing the oil from the bolt holes prevents the cylinder head from cracking when tightening the bolts. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-611