1.36 JAKE BRAKE 1.36.5.1 Adjustment of Slave Piston on Model 760, 765, or 770 Jake Brake Make the following adjustment with the engine stopped and cold, and the oil temperature at 60°C (140°F) or below. The exhaust valves on the cylinder must be in the closed position (rocker arm roller on the base circle of the camshaft). When setting the engine brake lash, the exhaust valves must be in the closed position. Adjust the slave piston on all models as follows: NOTE: The following procedures apply to Model 760, 765, and 770 Jake Brake. For Model 790/795 Jake Brake slave piston lash setting procedures, refer to section 1.36.8.1. NOTE:
Model 770 Jacobs engine brake requires a special procedure for adjusting the slave piston. The procedure is clearly indicated in the following adjustment steps. NOTICE: Improper slave piston adjustment can result in engine or brake housing damage. NOTICE: Strictly follow the slave piston adjustment procedure. Failure to use the proper adjustment procedure will result in poor engine brake performance and/or serious engine damage. 1. Refer to section 1.36 for proper slave piston clearance setting. (Rev. 2005) All information subject to change without notice. 1-618 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION