1. Grind the main bearing O.D. surface to the specified undersize. The undersize conditions are 0.254, 0.508 or 0.762 mm (approximately 0.010, 0.020, or 0.030 in.). NOTE: Avoid localized heating, which often produces grinding cracks. Cool the crankshaft generously with coolant while grinding. Do not crowd the grinding wheel into the work. 2. ALL main bearing journals must be ground to the same undersize conditions. 3. Journal taper on a radial basis shall not exceed 0.012 (0.0005 in.) overall or exceed 0.006 mm (0.00024 in.) on half-length. Other Machining Operations: Perform the following steps for other machining operations: 1. Examine the thrust wall (No. 4 main bearing):
[a] If the thrust wall surface is scored, scratched or groove worn, the thrust wall must be "bump ground." [b] The maximum run-out of the thrust wall is 0.038 mm (0.0015 in.) TIR. [c] If wear is 0.0508 mm (0.002 in.) or more, regrind to restore flatness to the thrust wall. See Figure 1-573. Figure 1-573 No. 6 Main Journal Thrust Wall Dimensions (Rev. 2005) All information subject to change without notice. 1-652 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION