Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

Exceptions to Standard Fastener Torque Specifications Listed in Tables 1-46 and 1-47 are exceptions to standard fastener torque specifications supporting the Series 60 Engine. Table 1-46 Exceptions to Standard Fastener Torque Specifications (1 of 2) (Rev. 2005) All information subject to change without notice. 1-684 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Section Fastener Size N m (lb·ft) Refer to section 1.6.3.1 Breather Housing to Rocker Cover Cap – 2.5 22 Refer to section 1.2.5 Cylinder Head Bolt (torque twice) Prior to 2002 M16 X 2.0 250 - 285 (184 - 210) Refer to section 1.2.5 Cylinder Head Bolt (torque twice) After 2002 — 298 (220) Refer to section 1.2.5 Bolt, Inj.

Harness Mounting Flange M8 X 1.25 10-15 (7-11) Refer to section 1.6.8 Bolt, Rocker Cover-to Cylinder Head (one piece cover) 3/8-16 20-25 (15-18) Refer to section 1.6.9 Bolt, Rocker Cover-to Cylinder Head (two & three piece) — 30-38 (22-28) Refer to section 1.9.3 Bolt, Main Bearing Cap M20 X 2.5 470-530 (347-391) Refer to section 1.12 Plug, Gear Case Adj. Idler Oil Hole 5/16-24 15-20 (11-15) Refer to section 1.15.3 Bolt, Front Pulley 9/16-18 182-210 (134-155) Refer to section 1.18.3 Bolt, Flywheel Hsg. Mounting 12 mm M12 X 1.75 112-126 (83-93) Refer to section 1.18.3 Bolt, Flywheel Hsg.

Mounting 14 mm — 160-200 (118-148) Refer to section 1.16.3 Bolt, Flywheel 9/16-18 75(+60°) (55)(+60°) Refer to section 1.22.4 Nut, Connecting Rod M14 X 1.5 160-185 (118-137) Refer to section 1.28.6 Bolt, Camshaft Bearing Cap M12 X 1.75 126-146 (93-108) Refer to section 1.36.5 Bolt, Rocker Arm Shaft — 136 100 Refer to section 1.28.6 Nut, Nos. 1&7 Camshaft Cap M12 X 1.75 126-146 (93-108) Refer to section 1.28.5 Stud, Nos. 1&7 Camshaft Cap M12 X 1.75 126-146 (93-108) Refer to section 1.29.4 Bolt (Solid), Camshaft Drive Gear M18 X 1.5 75( + 120°) (55 + 120°) Refer to section 1.24 Nut, Adjustable Idler Assy. M12 X 1.75 57-67 (42-49)