2.1 DIESEL FUEL SYSTEM OVERVIEW The fuel system includes injectors, integral fuel manifold in the cylinder head, fuel pump, a cooling plate for the Electronic Control Module (ECM) or Electronic Distributor Unit (EDU), a primary fuel filter, a secondary fuel filter, and a fuel check valve if equipped. A 2.0 mm (0.080 in.) restrictive orifice is located in the fuel return fitting at the rear of the cylinder head to maintain the pressure in the fuel system. See Figure 2-1 for fuel system diagram. FIRE To avoid injury from fire caused by heated diesel-fuel vapors: Keep those people who are not directly involved in servicing away from the engine. Stop the engine immediately if a fuel leak is detected.
Do not smoke or allow open flames when working on an operating engine. Wear adequate protective clothing (face shield, insulated gloves and apron, etc.). To prevent a buildup of potentially volatile vapors, keep the engine area well ventilated during operation. Fuel is drawn from the fuel tank through an optional fuel water separator, into the primary fuel filter and enters the pump. After leaving the fuel pump under pressure, the fuel flows through the EDU/ECM cooler plates (if equipped) through the secondary fuel filter to the cylinder head. For units prior to 6R56762, the fuel flows through a check valve prior to entering the cylinder head.
An optional PRO-CHEK® check valve that removes air from the fuel supply line may be installed between the secondary filter and the cylinder head. The fuel flows to the injectors in the cylinder head through passages integral with the head. Surplus fuel exits at the rear of the head just above the inlet, through a restrictive return fitting which maintains fuel pressure in the system and returns back to the fuel tank. NOTE: Effective with unit 6R8950, the cooler plate was removed from all Series 60 engines used in on-highway applications. Effective with unit 6R13060, a fuel system check valve is installed in the secondary fuel filter to prevent fuel drainback when filters are changed. NOTE:
Effective with 6R56762, a manually operated fuel shutoff valve has replaced the former valve. (Rev. 2005) All information subject to change without notice. 2-6 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION