SERIES 60 SERVICE MANUAL 1.1.3.1 Testing the Cylinder Block (Immersion Pressure Method) Use cylinder block pressure test kit (J–36223–D) for immersion method pressure testing as follows: 1. Install cylinder liners with new seal rings and crevice seals. Refer to section 1.23.3. Seat the liners firmly in the block counterbores with cylinder liner installation tool (J–35597–A). 2. Install two metric eye bolts (J–35595) in the head bolt holes at opposite ends of the block. See Figure 1-10. Figure 1-10 Cylinder Block Test Deck Plate Installation 3. Install the cylinder block test strips and rings. See Figure 1-10. 4. Install the bolts through the strips and into the cylinder block.
Torque the bolts on the ring strips to 230-237 N·m (170-175 lb·ft). Torque the bolts on the outside strips to 14 N·m (10 lb·ft). All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-15