SERIES 60 SERVICE MANUAL 1.1.3.3 Inspection of the Cylinder Block Perform the following for cylinder block inspection: 1. Remove the cylinder liners and check to determine whether liner replacement is necessary. Refer to section 1.23.2.2. 2. Measure the bore of each cylinder with cylinder bore gage (J–5347–B) which has a dial indicator calibrated in 0.0001 in. increments. See Figure 1-12. Figure 1-12 Gaging Cylinder Bores All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-19