2.7 FUEL PUMP WITH SEPARATE DRIVE SHAFT AND HUB 5. Remove the installer and reverse the adaptor, placing the narrow end against the installer handle. See Figure 2-52. Figure 2-52 Installing Outer Oil Seal 6. Place a second seal on the installer pilot with the seal case faced away from the adaptor. 7. Carefully reinsert the installer pilot through the inner seal and position the second outer seal on the bore. Use a light hammer and drive the seal into the bore until the adaptor is bottomed against the pump body. 8. Press a fuel pump gear positioning C-clip directly into inner groove of fuel pump drive shaft opposite the drive hub end of the shaft. 9.
Install drive key in slot on the drive shaft and slide the gear on the shaft indexing the keyway in the gear with the key. 10. Press a second C-clip directly into the groove behind the gear to retain it in position. 11. As the driven shaft is reversible, press a C-clip directly into either groove on the shaft. 12. Insert driven gear pin into its hole in the driven shaft with the square head of the pin parallel to the shaft. Slide the gear on the shaft indexing the keyway in the gear over the square head of the pin. 13. Press a second C-clip directly into the groove behind the gear to retain it in position. NOTE: The bearing numbers should always be against the tool during installation. (Rev.
2005) All information subject to change without notice. 2-70 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION