Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.7 FUEL PUMP WITH SEPARATE DRIVE SHAFT AND HUB 2.7.6 Installation of Former Air Compressor-Driven Fuel Pump Perform the following steps for fuel pump installation: NOTE: New fittings have sealant already applied. If reusing fittings, coat the threads lightly with Loctite® Pipe Sealant, PT-7260, or equivalent, before installing. To prevent sealant from entering fuel system, do not apply it to the first two (2) threads of the fitting. Do not use Teflon tape or paste on the fittings. 1. If removed, install inlet and outlet fittings in the rear cover of the fuel pump. 2. Install drive coupling in drive hub of the fuel pump and affix a new gasket to the mounting flange of the pump. NOTE:

When correctly positioned, the outlet fitting on the pump should be in approximately 8 o'clock position when viewed from the rear, and the drain opening in the pump body facing down. 3. Index the drive coupling with the drive hub on the end of the air compressor crankshaft and align the pump mounting bolt holes with those in the air compressor rear cover. 4. Seat the fuel pump squarely against the air compressor piloting the flange on the pump body in the opening in the rear cover of the compressor. Install three (3) fuel pump mounting bolts and torque them to 30-38 N·m (22-28 lb·ft). 5. Connect the fuel inlet and outlet lines to the fuel pump and tighten. 6.

Prime engine fuel system before starting engine to ensure pump seal lubrication and prompt engine starting. (Rev. 2005) All information subject to change without notice. 2-78 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION