Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.10 DIESEL FUEL FILTERS (SPIN-ON) Replace the fuel and water separator as follows: 1. Drain off some fuel by opening the drain valve. 2. Using a strap wrench, remove the element and bowl together. Remove the bowl from the element. The filter and bowl have standard right-hand threads, so turn counterclockwise to remove. 3. Clean the bowl and the O-ring seal. NOTICE: To avoid damaging the bowl or the filter, do not use tools when tightening. 4. Apply a light coating of clean fuel or grease to the O-ring seal, spin the bowl onto the new filter, and tighten by hand . 5. Apply a light coating of clean fuel or grease to the new O-ring seal on the top of the filter.

Spin the filter and bowl assembly onto the filter head, and tighten by hand until snug. 6. To eliminate air from the filter, operate the primer pump on the filter head (if equipped) until the fuel purges at the filter assembly. PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 7. Start the engine, and check for leaks. Correct any leaks with the engine off. (Rev.

2005) All information subject to change without notice. 2-110 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION