SERIES 60 SERVICE MANUAL 2.15.1 Repair or Replacement of the DDEC V Electronic Control Unit The DDEC V ECU is a sealed, nonserviceable unit. Tag defective ECU for recore. 2.15.2 Removal of the DDEC V Electronic Control Unit Perform the following steps for ECU removal: 1. Disconnect the vehicle battery power to prevent failure of the ECU. 2. Remove screw from center of shroud and connector. Remove two nuts from threaded studs at the base of the shroud and ECU see Figure 2-88. 3. Remove shroud and connector from ECU. 4. Remove the two through-bolts, two nuts and two studs holding the ECU to the engine, remove the ECU from engine. See Figure 2-88.
2.15.3 Installation of the DDEC V Electronic Control Unit Perform the following steps for ECU installation: 1. Inspect the ECU isolators for damage and replace if required. 2. Mount the ECU to the engine. 3. Secure the ECU to the engine with two through-bolts, two studs and nuts. Torque the ECU-to-engine bolts to 23-27 N·m (17-20 lb·ft). 4. Install the engine harness connector and shroud to the ECU. Torque center screw and two nuts to 5.6 N·m (50 in.· lb). 5. Reconnect vehicle battery power. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-139