SERIES 60 SERVICE MANUAL 2.16.1 Repair or Replacement of the DDEC III/IV Electronic Control Module The DDEC III/IV ECM is a sealed, nonserviceable unit. Tag defective ECM for recore. 2.16.2 Removal of the DDEC III/IV Electronic Control Module Perform the following steps for ECM removal: 1. Carefully disengage the lock tab on the power harness and injector harness connectors when removing. 2. Remove the two (2) wire and three (3) wire harness connections at the ECM. 3. Remove the two 30-pin connectors. 4. Remove the through-bolts holding the ECM to the engine. 5. Remove the ECM and cold plate from the engine, if so equipped. 6. Remove the screws securing the cold plate to the ECM.
Remove the cold plate from the ECM, if so equipped. 2.16.3 Installation of the DDEC III/IV Electronic Control Module Perform the following steps for ECM installation: 1. Install the cold plate on the ECM, if so equipped. Tighten the screws securing the cold plate to the ECM. Use Loctite® 262, or equivalent, on the cold plate-to-ECM screws. Torque to 9.5-12 N·m (84-106 lb·in.). 2. Inspect the ECM isolators for damage and replace if required. 3. Mount the ECM and cold plate to the engine. 4. Secure the ECM to the engine with through-bolts. Torque the ECM-to-engine bolts to 23-27 N·m (17-20 lb·ft). 5. Install the connectors in the ECM and torque the jack screws to 2.49–3.16 N·m (22–28 lb·in).
6. Engage the lock tab on the power harness and injector harness connectors. 7. Turn the ignition to the "ON" position. Observe the DDR for any diagnostic code(s). If any code(s) other than code 25 is logged, refer to the Detroit Diesel DDEC III/IV Single ECM Troubleshooting Manual (6SE497). All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-147