2.17 DDEC II ELECTRONIC CONTROL MODULE 2.17.6 Removal of the DDEC II EPROM Perform the following steps to remove the former EPROM: 1. Using a Diagnostic Data Reader (DDR) (J–38500–B), check for codes in the electronic control module (ECM). Note the codes. Erase the codes. 2. Remove the ECM from the engine and take to a clean environment. NOTICE: Failure to properly ground your hand while handling the ECM may result in damage to the EPROM, the ECM or both. 3. Fasten the wrist strap of tool BT-8639-B securely around your wrist and attach the test clip to a good ground. 4. Using the 1/4 in. nut driver, remove the 16 screws which fasten the ECM cover to the case. NOTICE:
Use care to avoid damaging the cover gasket on the ECM. A damaged cover gasket could allow contaminants to enter the ECM, which may cause damage. 5. Using the thin head standard screwdriver, carefully pry the cover loose from the case. 6. Early EPROM assemblies may have been installed in a blue 28-pin socket at the end of the ECM and under the stabilizer plate. To remove the EPROM assembly from its socket, push down (unlatch) the blue and white locking tabs and move them to the side. Remove the EPROM. Then, using a suitable narrow diameter tool, remove the locking tabs by carefully pressing out the pins holding the tabs to the socket. Discard the tabs and pins. (Rev.
2005) All information subject to change without notice. 2-156 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION