Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.17 DDEC II ELECTRONIC CONTROL MODULE NOTICE: Use care to avoid damaging the cover gasket on the ECM. A damaged cover gasket could allow contaminants to enter the ECM, which may cause damage. 4. Carefully inspect the cover gasket for any damage or areas where a dust leak could possibly occur. NOTE: If the gasket is damaged, it must be replaced with a new gasket. 5. Fasten the cover to the case with the 16 previously removed #8 - 32 x 1/2 in. screws. Torque screws to 2.0-2.2 N·m (17.7-19.5 lb·in.). 6. Remove the wrist strap and ground clip of tool BT-8639-B and store for next use. 7. Test the EPROM for proper installation. Refer to section 2.17.7. 8. Install the ECM on the engine.

Refer to section 2.17.4. 2.17.7.1 Testing of the ECM The resistance of the ECM to block must be checked after installation. Use the following procedure: 1. With the six-pin connector unplugged, connect the leads of an ohmmeter between the ECM case and the engine. 2. Return the removed EPROM assembly to an authorized Detroit Diesel distributor. (Rev. 2005) All information subject to change without notice. 2-158 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION