Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.18 DDEC I 2.18.2 Removal of DDEC I Electronic Control Module Perform the following steps for ECM removal: 1. Loosen, but do not remove, the two hold-down screws attaching the wire harness connectors to the ECM. 2. Pull gently on the connectors and remove them from the ECM sockets. 3. Remove the three bolts securing the ECM to the vehicle. 4. Remove the ECM from the vehicle. 5. If the programmable read-only memory (PROM) is to be reused, remove it from the ECM using the PROM removal instructions; refer to section 2.19.2. 2.18.3 Installation of DDEC I Electronic Control Module Perform the following steps for ECM installation: 1. Secure the ECM to the vehicle using three bolts.

Torque the ECM connector hold-down screws to 2.4-3.0 N·m (21-26 lb·in.). The three bolts that secure the ECM to the vehicle should be torqued to 16 N·m (12 lb·ft). 2. Install connectors in ECM sockets. 3. Tighten the two hold-down screws attaching the wire harness connectors to the ECM. 4. Turn the ignition to the ON position. Observe the DDR for any diagnostic code(s). If any code(s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497). (Rev. 2005) All information subject to change without notice. 2-164 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION