Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.29.1 Repair or Replacement of Coolant Temperature Sensor The CTS is non-serviceable, and is replaced as a unit. No adjustment is required. 2.29.2 Removal of Coolant Temperature Sensor Remove the CTS as follows: 1. Disengage locking tang on two wire connector. 2. Grasp body of the connector and gently pull it from the socket. 3. Use the appropriate wrench on the hex portion of the sensor and unscrew it from the cylinder head. 2.29.3 Installation of Coolant Temperature Sensor Install the CTS as follows: 1. Apply Loctite® pipe sealant with Teflon PT-7260 or equivalent on all but first two threads. 2. Install CTS to the cylinder head. 3.

Torque to 102-127 N·m (75-94 lb·ft). 4. Carefully fasten two-wire connector onto sensor and engage locking tang. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-191