Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL The bull gear pin passes by the SRS as the number one piston reaches approximately 45 degrees before Top-Dead-Center (TDC). This information is used by the ECM to determine number one piston in the firing order. 2.30.1 Replacement of Synchronous Reference Sensor The SRS is a non-serviceable item and is replaced as a unit. No adjustment is required. 2.30.2 Removal of Synchronous Reference Sensor Remove the SRS as follows: 1. Disengage the locking tang on the SRS connector. Grasp the connector bodies and gently pull them apart. 2. Using a socket and long extension, remove the SRS bolt. 3. Remove the SRS by pulling it straight out of the gear case.

2.30.3 Installation of Synchronous Reference Sensor Install the SRS as follows: NOTE: The SRS is an electronic component. Use care upon installation. 1. The O-ring on the sensor may be coated with clean engine oil for ease of installation. 2. Insert the SRS into the gear case and index the hole in the bracket with the hole in the gear case. 3. Insert the SRS bolt and torque it to 30-38 N·m (22-28 lb·ft). 4. Plug the connectors together, making sure the locking tang clicks into place. 5. Turn the ignition to the ON position. Observe the DDR for any diagnostic code(s). If any code(s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497).

All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-193