2.31 SYNCHRONOUS REFERENCE SENSOR \ CAMSHAFT POSITION SENSOR CAMSHAFT GEAR COVER MOUNTED 2.31.1 Replacement of the Synchronous Reference Sensor \ Camshaft Position Sensor The SRS\CMP is a non-serviceable item and is replaced as a unit. 2.31.2 Removal of the Synchronous Reference Sensor \ Camshaft Position Sensor Remove the SRS\CMP as follows: 1. Disengage the locking tang on the SRS\CMP connector. Grasp the connector bodies and gently pull them apart. 2. Using a socket and long extension, remove the SRS\CMP bolt. 3. Remove the SRS\CMP by pulling it straight out of the gear cover.
2.31.3 Installation of the Synchronous Reference Sensor \ Camshaft Position Sensor Install the SRS\CMP as follows: NOTE: The SRS\CMP is an electronic component. Use care upon installation. 1. The O-ring on the sensor may be coated with clean engine oil for ease of installation. 2. Insert the SRS\CMP into the gear cover and index the hole in the bracket with the hole in the gear cover. 3. Insert the SRS\CMP bolt and torque it to 30-38 N·m (22-28 lb·ft). 4. Plug the connectors together, making sure the locking tang clicks into place. 5. Turn the ignition to the ON position. Observe the DDR or DDDL for any diagnostic code(s).
If any code(s) other than code 25 is logged, refer to the Detroit Diesel Series 60 Troubleshooting Guide (6SE570). (Rev. 2005) All information subject to change without notice. 2-196 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION