Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Listed in Table 2-17are the knock sensor and knock interface module diagnostic codes: Table 2-17 Knock Sensor Diagnostic Codes for the Series 60G Engine All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-213 Description Voltage SID FMI Information Knock Control HIGH S76 3 Indicates that the knock sensor input to the ECM has exceeded 95% (normally >4.75 volts) of the sensor supply voltage. This diagnostic is typically detected when there is an open sensor return circuit or the sensor signal circuit is shorted to the sensor +5 volt supply.

Knock Control LOW S76 4 Indicates that the knock sensor input to the ECM has dropped below 5% (normal Knock Control HIGH S76 0 Indicates that the knock interface module has detected that the engine knock level has exceeded the first level of the recommended engine operational range. Knock Control MECHANICAL FAULT S76 7 Indicates that the knock interface module has detected that the engine knock level has exceeded the second level of the recommended engine operational range.