SERIES 60 SERVICE MANUAL 2.41 FUEL PRESSURE GAGES FOR THE SERIES 60G ENGINE WITH A HIGH PRESSURE FUEL SYSTEM Fuel pressure gages should be installed on both high and low pressure sides of fuel system. The high pressure gage should have a range of 0 - 27580 kPa (0 - 4000 psi) mounted between the tank and 1st stage regulator. The low pressure gage should have a range of 0 - 1380 kPa (0 - 200 psi). 2.41.1 Replacement of Fuel Pressure Gages for the Series 60G Engine Detroit Diesel does not service the fuel pressure gages. Refer to OEM to replace as necessary.
2.41.2 Removal of Fuel Pressure Gages for the Series 60G Engine Prior to removal or replacement of fuel system pressure gages, the fuel system must be vented. Refer to section 2.42.1 and refer to section 2.42.2. EXPLOSION To avoid injury from the explosion of natural gas, the engine must be kept in a well ventilated area away from open flames, sparks, and electrical resistance (heating) coils. Refer to OEM for removal procedure for the fuel pressure gages. 2.41.2.1 Inspection of Fuel Pressure Gages for the Series 60G Engine Refer to OEM for inspection procedure for the fuel pressure gages.
2.41.3 Installation of Fuel Pressure Gages for the Series 60G Engine Refer to OEM for installation procedure for the fuel pressure gages. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-223