SERIES 60 SERVICE MANUAL 2.45.1 Replacement of Fuel Mixer for the Series 60G Engine High Pressure Fuel System The fuel mixer is non-serviceable and should be replaced as a unit. No adjustment is required. 2.45.2 Removal of Fuel Mixer for the Series 60G Engine High Pressure Fuel System Remove the fuel mixer as follows: To avoid injury from the explosion of natural gas, the engine must be kept in a well ventilated area away from open flames, sparks, and electrical resistance (heating) coils. EXPLOSION 1. Vent fuel system; refer to section 2.51.1and refer to section 2.51.2. 2. Disconnect hose between mixer and charge cooler outlet tube. 3.
Disconnect and remove the PSV from the fuel mixer, refer to section 2.44.2. 4. Disconnect air balance hose at mixer. 5. Remove four fuel mixer mounting bolts. 6. Separate and remove the fuel mixer from the throttle. 2.45.3 Installation of Fuel Mixer for the Series 60G Engine High Pressure Fuel System Install the fuel mixer as follows: 1. Clean gasket surface and install a new gasket. 2. Secure the fuel mixer to the throttle with four bolts finger-tight. 3. Install the PSV to the fuel mixer, refer to section 2.44.3. 4. Connect air balance hose to PSV and mixer. 5. Torque mixer bolts to 20 N·m (15 lb·ft). 6. Connect hose between mixer and charge cooler outlet tube.
All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-235