Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.46 FUEL SHUTOFF VALVE FOR SERIES 60G ENGINE WITH HIGH PRESSURE FUEL SYSTEM 2.46.1 Replacement of the Fuel Shutoff Valve for the Series 60G Engine The fuel shutoff valve is not serviceable and should be replaced as a unit. No adjustment is required. 2.46.2 Removal of the Fuel Shutoff Valve for the Series 60G Engine Remove the fuel shutoff valve as follows: 1. Vent fuel system, refer to section 2.51. 2. Disconnect fuel supply pipe at shutoff inlet. 3. Disconnect fuel pipe from shutoff outlet. 4. Disconnect electrical connector. 5. Remove two bolts attaching the shutoff valve bracket to its mounting bracket and remove shutoff valve and bracket assembly.

2.46.3 Installation of the Fuel Shutoff Valve for the Series 60G Engine Install the fuel shutoff valve as follows: 1. Install gas inlet and outlet fittings. 2. Position shutoff valve on mounting bracket. 3. Install mounting bolts. 4. Connect fuel outlet hose to outlet fitting. 5. Connect fuel supply pipe to inlet fitting. 6. Connect solenoid electrical connector to connector in vehicle wire harness. 7. Open manual fuel shutoff valves and crank engine to supply fuel. 8. Check for leaks, refer to section 2.51.3. (Rev. 2005) All information subject to change without notice. 2-238 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION