Perkins — To remove and to fit Operation 4-1

400 Series 4 Piston and connecting rod assemblies 4 Big end bearing and cap To remove and to fit Operation 4-1 Engine Torque Nm (lbf ft) kgf m 403C-11 Nut 32 (23.6) 3,3 403C-15, 404C-22 and 404C-22T Nut 52 (38.3) 5,2 Standard clearance Service limit 0,1 - 0,3 mm (0.004 - 0.012 in) 0,7 mm (0.276 in) Caution: Ensure that the connecting rod bolts (2) do not damage the crankshaft when the connecting rod is removed or fitted. Notes: The connecting rods and caps are numbered matched pairs and must be kept together when removed from the engine. The numbers (1) must be aligned when assembled.

The piston and connecting rods are matched to a cylinder, record the position of each connecting rod and piston for correct assembly. After the connecting rods are fitted check for axial movement. The fuel adjustment screw must not be altered from the original setting. The maximum no load speed must be checked after assembly. 2 1 H1054 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential: Green 33