400 Series 4 To measure the piston ring clearance Operation 4-5 Use a feeler gauge to measure the clearance between the piston ring groove and the piston ring. If the clearance is greater than the service limit, use a new piston ring and check the clearance again. If the clearance is within the service limit with a new piston ring, renew the piston rings. If the clearance is outside the service limit with a new piston ring, renew the piston. Note: The number 1 piston ring of the 404C-22T is of the ‘keystone’ design, therefore it is difficult to measure the wear due to it’s position in the piston ring groove.
When either number 2 ring or the oil control ring is outside the service limit renew all rings. H1058 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential:
Green 37 Engine Torque Nm (lbf ft) kgf m Standard Service limit 403C-11 Number 1 ring Number 2 ring Oil control ring 0,06 - 0,10 mm (0.0024 - 0.0039 in) 0,25 (0.0098 in) 0,05 - 0,09 mm (0.0020 - 0.0035 in) 0,25 (0.0098 in) 0,02 - 0,06 mm (0.0008 - 0.0024 in) 0,15 (0.0059 in) 403C-15 404C-22 Number 1 ring Number 2 ring Oil control ring 0,07 - 0,11 mm (0.0028 - 0.0043 in) 0,25 (0.0098 in) 0,04 - 0,08 mm (0.0016 - 0.0032 in) 0,25 (0.0098 in) 0,02 - 0,06 mm (0.0008 - 0.0024 in) 0,15 (0.0059 in) 404C-22T Number 2 ring Oil control ring 0,04 - 0,08 mm (0.0016 - 0.0032 in) 0,25 (0.0098 in) 0,02 - 0,06 mm (0.0008 - 0.0024 in) 0,15 (0.0059 in)