Perkins — To fit Operation 6-2

6 400 Series To fit Operation 6-2 Engine Special tools 403C-11 Front oil seal protector 21825620 Description Part number 403C-15 404C-22 404C-22T Front oil seal protector 21825621 To fit 1 The fuel injection pump, see Operation 11-3 and the keyway in the crankshaft must be removed before the timing case is fitted. Fit the front oil seal protector. 2 To fit the PTO cover, see Operation 6-9. 3 Ensure the oil pin (3) locates in the hole in the idler gear and that the stop lever arm (1) is held clockwise in tension for removal and assembly. 4 Remove the oil seal protector (4) after fitting the timing cover. Fit the key into the key way in the crankshaft nose.

5 To fit the crankshaft pulley, see Operation 5-1. Note: If the timing case is renewed, a new emission label must be fitted as shown (2). Caution: If the timing case assembly or internal governor components are replaced the fuel adjustment screw should not be adjusted. The maximum no load speed should be checked after assembly. 3 1 2 4 H1069 52 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential: Green