400 Series 8 6 Connect a suitable clean fuel reservoir (1), which has a tap and contains approximately 0,2 litres (ј pint) of clean fuel, to the fuel injection pump inlet. 7 Put a suitable waste fuel (3) container below the pipe neck and open the tap, if set correctly the fuel should flow. Note: The fuel reservoir should be approximately 152 mm (6 in) above the fuel injection pump. 8 Turn the crankshaft slowly until the fuel flow reduces to a drop which falls every 7 - 10 seconds. This is then the timing point. 9 Use the value shown by the timing mark (2) with the injection timing tables on page 69.
Continued 1 10 TOP 20 30 3 2 H1087 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential: Green 71