ENGINE MAINTENANCE - Maintenance Procedures Hose condition, deterioration/ signs of leaking Hose clamp torque Fan Belt Tensioner automatic belt tensioner's roller, as shown in the image. Maintenance checks for fan belt tensioner. Perform these maintenance procedures according to the Preventative Maintenance Schedule. 4. Rotate the flex-bar as shown in the diagram to relieve belt tension. 5. With the belt tensioner pressure relieved, remove the poly V-belt from the pulleys. 2 Drive Belts Maintenance checks and procedures for engine drive belts. 1. Check and correct fan belt tensioner.
Mounting bolt torque Tensioner maintains proper belt tension The tensioner can be temporarily blocked with a 0.16-0.2 in. (4-5 mm) thick pin (bore). This facilitates removal and installation of the poly V-belt. 6. After removing the belt, carefully allow the belt tensioner to spring back to the stop (if it had not been temporarily blocked). 7. Inspect the pulleys for damage, rust, and grease deposits. Clean or replace as necessary. NOTE Always fit the same type of belts as the ones replaced. Poly V-belt and Fan Drive Belt Removal Engine Belt Checks Engine belt replacement procedures for poly V-belt and fan drive belts. Maintenance check for engine drive belts.
Perform these maintenance procedures according to the Preventative Maintenance Schedule. Perform these maintenance procedures according to the Preventative Maintenance Schedule. 1. Disconnect the electrical ground wire from the battery. 2. Reach between the fan blades and remove the fan blade mounting bolts using a 9/16 in. socket to remove the mounting nuts. 3. Place a flex-bar with a 15 mm socket on the fastener securing the Poly V-belt and Fan Drive Belt Installation 1. Inspect the engine drive belts for the following conditions: Procedure to install poly v-belt and fan drive engine belts.
Condition, signs of wear/ deterioration Alignment Follow the steps below to install the poly V- belt and fan drive belts: Y53-1185-1E1 (04/16/18) 65