Komatsu — 13.5 REMOVAL AND INSTALLATION OF CAB

13. TRANSPORTATION 13.5.2 INSTALLATION OF CAB Install the parts removed from the cab in the opposite order from removal, and connect the parts that were disconnected. However, when installing the cab, install in the following order. Installation of cab 1. Set height adjustment joint 0 installed to the cab so that dimension S in the diagram is less than 8 mm (0.3 in). 2. Lower the cab slowly from above the floor. 3. Align the cab with the floor frame, then install bolts and washers @ - @. Do not screw in the bolts completely; screw in only 3 - 4 turns. 4. Tighten bolts @I - @ completely.

When tightening bolts @ - 0, check that height adjustment joint @ for installing @ - @ is not in contact with the floor frame mounting surface. 5. Screw in adjustment joint 0 of bolt sprocket @ - 0 until it contacts the floor frame mounting surface. a WARNING After the tip of the adjustment joint contacts the floor frame surface, do not tighten the joint with a wrench. This will deform the cab or floor frame and will generate initial stress. 6. After adjusting the joint, tighten cab mounting bolts @ - 0. 2-79