Komatsu — 13.5 REMOVAL AND INSTALLATION OF CAB

13. TRANSPORTATION 6. Pull out left and right knobs @ of the car stereo and remove, then loosen the nuts and remove holder plate @I. 7. Remove 10 caps @ installed to the top of the panel. 8. Remove 18 panel mounting screws 0 and washers 0, then remove panels 0, @, and @. 9. Remove 6 mounting screws @ and washers @ on the left and right, then remove 2 door seal protection plates @ on the left and right. 10. Remove 7 blind caps @ installed to the bottom front of the cab and the bottom of the left and right doors. After removing the cab, install blind caps @ again. 11. Disconnect wiring harness connectors @ and @ extending from the left side of the cab.

Hold concave portion @ of the connector with your fingers, then pull up to remove. Connector @: Air conditioner power source, 17 pins Connector 0: Cab, display power source, 21 pins 12. Pull up and remove 4 hoses @ extending from the left side of the cab. AE105781 13. Remove 14 cab mounting bolts @ - 0. The 2 seal rubbers @ (for blocking the clearance) are used again when the cab is installed, so keep them in a safe place. Cab weight: Approx. 450 kg (992 lb) REMARK I I AE105791 2-78