Komatsu — 13.5 REMOVAL AND INSTALLATION OF CAB

13. TRANSPORTATION 13.4 PRECAUTIONS FOR TRANSPORTATION Blo account the width, height and weight of the machine. Obey all state and local laws governing the weight, width and length of a load. Observe all regulations governing wide loads. 13.5 REMOVAL AND INSTALLATION OF CAB When removing the cab for transportation, do as follows. AEl05.760 a WARNING Always use lifting equipment of ample strength. I 13.5.1 REMOVAL OF CAB 1. Remove clamp @ and cable connector @ at the air conditioner unit end. The clamp and the cable connector can be seen at the back after removing fresh air filter 0. 2. Remove cab control panel @ from the cab panel, then pull out control cable @ 20 - 40 mm (0.8 - 1.6 in). 3.

Remove clamp @ and cable connector 0 from control panel 0. 4. Return control cable @ (pulled out in Step 2) to its original position. 5. Install cable connector @ and clamp @ at the air conditioner unit end. Cab panel A connection Control cable AL131770 2-77