24.4.4 CHECK, ADJUST ALTERNATOR DRIVE BELT TENSION CHECK The standard deflection for the drive belt is approx. 15 mm (0.59 in) when pressed by thumb (approx. 6 kg (13.23 lb)) at a point midway between the drive pulley and alternator pulley. ADJUSTING Loosen bolts @ and nuts 0. Alternator pulley Rotate turnbuckle @ and move alternator so that the deflection of the belt is approx. 15 mm (0.6 in) (approx. 6 kg (13 lb)). (0.6 in) About 15mm Tighten bolts @ and nuts @ to secure alternator in position. When tightening nuts 0, hold the bolt on both sides to prevent it from turning together with the nuts.
% Drive pulley AD053430 Check for damage to each pulley, wear of the V-groove, and wear of the V-belt. Check in particular that the V-belt does not contact the bottom of the V-groove. If the V-belt is elongated and there is no more allowance for adjustment, or if the belt is cracked or cut, replace the belt. When adjusting the V-belt, do not push the alternator directly with a bar. Insert a wooden block and push the block with a bar. After replacing the V-belt, operate the machine for one hour, then check and adjust again. 3-49