24. SERVICE PROCEDURE 24.4.5 CHECK LEVEL OF BATTERY ELECTROLYTE Carry out this check before operating the machine. -------A WARNING l To avoid gas explosions, do not bring fire or sparks near the battery. l Battery electrolyte is dangerous. If it gets in your eyes or on your skin, wash it off with large amounts of water, and consult a doctor. 1. Open the battery cover. 2. Remove cap 0, and check that the electrolyte is at the specified level (IO to 12 mm (0.39 to 0.47 in) above the plate). If the electrolyte level is low, add distilled water to the specified level. If the battery electrolyte is spilled, have dilute sulphuric acid added. 3.
When adding distilled water to any cell at cap 0, add distilled water also to the other cells. 4. Clean the air hole in the battery cap, then tighten the cap securely. NOTICE When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. 24, .4.6 DRAIN WATER AND SEDIMENT FROM FUEL FILTER Loosen air bleeding plug @ and remove drain plug @ on the bottom of the filter to drain water and sediment accumulated on the bottom of the fuel filter. After draining, loosen the knob of feed pump @ and move the knob up and down to bleed air. When no air bubbles come out of the air bleeding plug hole, tighten the plug and the knob. 1.
2. 3-50