Komatsu — 24.7 EVERY 2000 HOURS SERVICE

24. SERVICE PROCEDURE 24. 57.4 CHECK PIVOT BEARING OIL LEVEL, ADD OIL 1. Remove plug 0. When removing plug (iJ, be careful not to let dirt or dust get it. 2. Check that the oil is at the level shown in the diagram. If the oil level is low, add engine oil through the hole of plug 0. For details of the fuel to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 24 1. ..7.5 CLEAN ENGINE BREATHER ELEMENT Loosen clamp 0, then remove the hose. 2. Remove bolt 0, then remove breather body 0. 3. Wash the whole breather in desel oil or flushing oil, then blow it dry with compressed air. 4.

Replace the breather O-ring with a new part, coat with engine oil, and install it. 5. Check the breather hose, and it there is any oil sludge on the inside, replace it with a new hose. \ AL116820 24.7.6 CHECK PLAY OF TURBOCHARGER ROTOR Contact your Komatsu distributor for cleaning or inspection. 24.7.7 CHECK PLAY OF TURBOCHARGER ROTOR Contact your Komatsu distributor to have the play checked. 24.7.8 CHECK ENGINE VALVE CLEARANCE, ADJUST The brush may be worn, or the bearing may have run out of grease, so contact your Komatsu distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1000 hours.

24.7.9 CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, you shall request Komatsu distributor for service. 3-61