Komatsu — 11.4 CONTROL LEVERS AND PEDALS

11. EXPLANATION OF COMPONENTS 7. SAFETY LOCK (For blade control lever) I - - When leaving the securelv to the LOCK position. If the control lever is not locked,-and it is touched by mistake, this may lead to a serious accident. If the safety lock is not placed securely in the LOCK position, the control lever may not be properly locked. Check that the situation is as shown in the diagram. When parking or servicing the machine, be sure to lower the blade and set the safety lock in the LOCK position. After stopping the engine, if the work equipment control lever is operated to the LOWER position, the work equipment will go down under its own weight.

This is the locking device of blade control lever. l Method of releasing pressure in work equipment circuit 1. Lower the work equipment and stop the engine. 2. After stopping the engine, operate the work equipment control lever fully to the front, rear, left, and right to release the pressure inside the work equipment circuit. 8. RIPPER CONTROL LEVER This is used to operate the ripper. D 3 \ @ RAISE (9 1 @ HOLD ( 7 1: Ripper is stopped and held in the same position. @ LOWER( Tr ) @ Digging angle reduced ( 9& ) smaller. : Cutting angle (4 becomes \I’ AElO4700 @I Digging angle increased ( q3 larger. ): Cutting angle (a) becomes Digging Digging angle decrease angle decrease m04800 2-20